ACL Race Series Connecting Rod Bushes - Opel and General Motors 16N, 16SH, and 16D - 0.50 mm - 4B2322H-0.50

ACL
Reference: ACL-4B2322H-050
Supplier Ref.: 4B2322H-0.50

Price: €64.90 Tax included
In stock Shipped tomorrow from our warehouse
Available in store (Montpellier)
Earn 64 loyalty points
Carbon footprint: 3 kg CO₂

The ACL Race Series 4B2322H-0.50 trimetal connecting rod bushes are designed for Opel, General Motors, and Holden 16N, 16SH, and 16D engines. In the lower engine, they allow the connecting rods to rotate around the crankpins while supporting the loads transmitted by the pistons. The part number 4B2322H-0.50 corresponds to a thickness of 0.50 mm.

Developed to withstand the stresses of engine tuning, ACL Race Series trimetal bearings combine a steel bracket, a copper-lead-tin alloy, a nickel barrier, and an anti-friction layer. Their radial runout helps maintain the oil film when the bearing seats undergo deformation during operation.

This 0.50 mm version allows you to select bearings that match the actual condition of the crankshaft journals. The selection should be based on crankshaft measurements and not solely on the engine’s tuning level.


Technical Specifications

  • Type: connecting rod bushes
  • Manufacturer: ACL
  • Range: ACL Race Series
  • Design: trimetal, steel backing, and copper-lead-tin anti-friction plies
  • ACL Material: F781 (Race Series connecting rod bushes)
  • Manufacturer part number: 4B2322H-0.50
  • Thickness: 0.50 mm
  • Version: H
  • Main engines: 16N, 16SH, and 16D
  • Manufacturers: Opel | General Motors | Holden

Engine configurations compatible with ACL 4B2322H-0.50 bearings

This part number applies specifically to the following engine models in the described family: 16N | 16SH | 16D | 16DA | 18E | 18N | 18NV | 18S | 18SE | 18SEH | 18SV | C18NE | C18NT | C18NV | C18NZ | C18XE | C18XEL | E18NV | E18NVR | S18NV. The list of engine codes and applications must be verified against the exact mounting configuration before ordering.

Mounting Recommendations

Mounting Recommendation: Before assembly, verify the geometry of the connecting rod top ends, the actual dimension of the crankshaft journals, and the final oil clearance. Apply the torque values and follow the tightening sequence specified for the engine. A replacement-sized bearing should only be installed if the corresponding machining has been performed.

ACL Race Series develops engine bearings for competition and tuning applications, featuring precision manufacturing, shell thickness control, and a trimetal design focused on mechanical resistance and precise control of operating clearances.

  • Thickness in mm
    1,75
  • Width in mm
    19,30
  • Make (Engine)
    General Motors
    Holden
    Opel
  • Rod Journal Diameter in mm
    48,47
    48,49
  • Max. connecting rod bore in mm
    52,01
  • Min. connecting rod bore in mm
    52,00

16 other products in the same category: