ACL Race Series Connecting Rod Bushes - Toyota 4A, 4AGE, and 4AGZE - STD - 4B1780HX-STD
The ACL Race Series 4B1780HX-STD connecting rod bushes, featuring a trimetal construction, are designed for Toyota’s 4A, 4AGE, and 4AGZE engines. They guide the connecting rod top ends over the crankshaft journals and operate using the oil film that separates the moving surfaces. Part number 4B1780HX-STD corresponds to the standard size (STD).
The trimetal design combines a high-strength steel backing, a copper-lead-tin anti-friction layer, a nickel barrier, and a lead-tin-copper surface trim. This structure helps withstand the stresses of the lower engine while maintaining optimal conditions for oil film formation.
The HX suffix identifies a version designed to adjust the oil clearance. For the HX version, ACL specifies approximately 0.025 mm of additional clearance compared to an H version of the same size, on a crankshaft of corresponding sizes. The mounting must be checked after the connecting rod caps are tightened.
Technical Specifications
- Type: connecting rod bushes
- Manufacturer: ACL
- Range: ACL Race Series
- Design: trimetal, steel backing, and copper-lead-tin anti-friction plies
- ACL Material: F781 (Race Series connecting rod bushes)
- Manufacturer Part Number: 4B1780HX-STD
- Dimension: standard dimension (STD)
- Version: HX, increased oil clearance compared to the corresponding H version
- Main engines: 4A, 4AGE, and 4AGZE
- Manufacturers: Toyota
- Rod journal diameter (nominal dimension): 41.985 to 42 mm
- Connecting rod top end bore: 45 to 45.024 mm
- Maximum thickness at the top: 1.474 mm
- Maximum width: 17.1 mm
Engine models compatible with ACL 4B1780HX-STD bearings
The engine models listed for this set include: 4A | 4AGE | 4AGZE.
Mounting Recommendations
Mounting recommendation: Measure the crankshaft journals with a micrometer, inspect the connecting rod bearings, and check the operating clearance after tightening the connecting rod caps in accordance with the engine manufacturer’s specifications.
ACL Race Series develops engine bearings for competition and performance tuning, featuring precision manufacturing, shell thickness control, and a trimetal design focused on mechanical resistance and precise control of operating clearances.
-
Thickness in mm1,47
-
Width in mm17,10
-
Engine code4A - 1.6L 16V
4A - 1.6L 20V -
Make (Engine)Toyota
-
Rod Journal Diameter in mm41,99
42,00 -
Max. connecting rod bore in mm45,02
-
Min. connecting rod bore in mm45,00