ACL Race Series Connecting Rod Bushes - Opel and General Motors C20LET, C20XE, and Z20LET - STD - 4B2322HX-STD
The ACL Race Series 4B2322HX-STD connecting rod bushes, featuring a trimetal construction, are designed for Opel, General Motors, and Holden C20LET, C20XE, and Z20LET engines. They guide the connecting rod top ends over the crankpins and operate using the oil film that separates the moving surfaces. Part number 4B2322HX-STD corresponds to the standard size (STD).
The trimetal design combines a high-strength steel backing, a copper-lead-tin anti-friction ply, a nickel barrier, and a lead-tin-copper surface trim. This structure helps withstand the stresses of the lower engine while maintaining the conditions necessary for oil film formation.
The HX suffix identifies a version designed to adjust the oil clearance. For the HX version, ACL specifies approximately 0.025 mm of additional clearance compared to an H version of the same size, on a crankshaft of corresponding sizes. The mounting must be checked after tightening the connecting rod caps.
Technical Specifications
- Type: connecting rod bush
- Manufacturer: ACL
- Range: ACL Race Series
- Design: trimetal, steel backing, and copper-lead-tin anti-friction plies
- ACL Material: F781 (Race Series connecting rod bushes)
- Manufacturer part number: 4B2322HX-STD
- Dimension: standard dimension (STD)
- Version: HX, increased oil clearance compared to the corresponding H version
- Main engines: C20LET, C20XE, and Z20LET
- Manufacturers: Opel | General Motors | Holden
- Rod journal diameter (nominal dimension): 48.971 to 48.987 mm
- Connecting rod top end bore: 52 to 52.012 mm
- Maximum thickness at the top: 1.485 mm
- Maximum width: 19.3 mm
Engine configurations compatible with ACL 4B2322HX-STD bearings
This part number applies specifically to the following engine models in the described family: C20LET | C20XE | Z20LET | 16N | 16SH | 16D | 16DA | 18E | 18N | 18NV | 18S | 18SE | 18SEH | 18SV | C18NE | C18NT | C18NV | C18NZ | C18XE | C18XEL. The list of engine codes and applications must be verified against the exact mounting before ordering.
Mounting Recommendations
Mounting recommendation: Measure the crankshaft journals with a micrometer, inspect the connecting rod bearings, and check the operating clearance after tightening the connecting rod caps in accordance with the engine manufacturer’s specifications.
ACL Race Series develops engine bearings for racing and tuning applications, featuring precision manufacturing, shell thickness control, and a trimetal design focused on mechanical resistance and precise control of operating clearances.
-
Thickness in mm1,49
-
Width in mm19,30
-
Engine codeC20LET - 2.0L 16V
C20XE - 2.0L 16V
Z20LET - 2.0L 16V -
Make (Engine)General Motors
Holden
Opel -
Rod Journal Diameter in mm48,97
48,99 -
Max. connecting rod bore in mm52,01
-
Min. connecting rod bore in mm52,00