ACL Race Series Connecting Rod Bushes - BMW M42B18, M40B16, and M40B18 - STD - 4B1490HX-STD
ACL Race Series 4B1490HX-STD trimetal connecting rod bushes are designed for BMW M42B18, M40B16, and M40B18 engines. Installed in the connecting rod top ends, they serve as the interface between the connecting rod and the crankshaft. Their selection determines the operating clearance and oiling of the lower engine. Part number 4B1490HX-STD corresponds to the standard size (STD).
ACL Race Series trimetal technology consists of a steel bracket and a copper-lead-tin layer protected by a nickel barrier. The assembly is completed by a surface layer designed to enhance bearing performance under load and resistance to seizure.
The HX suffix identifies a version designed to adjust the oil clearance. For the HX version, ACL specifies approximately 0.025 mm of additional clearance compared to an H version of the same size, on a crankshaft of corresponding sizes. The mounting must be checked after tightening of the connecting rod caps.
Technical Specifications
- Type: connecting rod bushes
- Manufacturer: ACL
- Range: ACL Race Series
- Design: trimetal, steel backing, and copper-lead-tin anti-friction plies
- ACL Material: F781 (Race Series connecting rod bushes)
- Manufacturer part number: 4B1490HX-STD
- Dimension: standard dimension (STD)
- Version: HX, increased oil clearance compared to the corresponding H version
- Main engines: M42B18, M40B16, and M40B18
- Manufacturers: BMW
- Rod journal diameter (nominal dimension): 44.975 to 44.991 mm
- Connecting rod top end bore: 48 to 48.016 mm
- Maximum thickness at the top: 1.477 mm
- Maximum width: 18 mm
Engine models compatible with ACL 4B1490HX-STD bearings
The engine models listed for this set include: M42B18 | M40B16 | M40B18 | M43B16 | M43B18 | M43B19 | M44B19.
Mounting Recommendations
Mounting recommendation: Check the surface condition of the crankshaft, measure the diameters of the crankpins, and measure the oil clearance with the half-bearings installed. Follow the engine tightening procedure.
ACL Race Series develops engine bearings for competition and tuning, featuring precision manufacturing, shell thickness control, and a trimetal design focused on mechanical strength and precise control of operating clearances.
-
Thickness in mm1,48
-
Width in mm18,00
-
Engine codeM42B18 - 1.8L 16V
-
Make (Engine)BMW
-
Rod Journal Diameter in mm44,98
44,99 -
Max. connecting rod bore in mm48,02
-
Min. connecting rod bore in mm48,00