ACL Race Series Connecting Rod Bushes - Volkswagen and Audi VR6 - STD - 6B5530HX-STD
The ACL Race Series 6B5530HX-STD trimetal connecting rod bushes are designed for Volkswagen and Audi VR6 engines. In the lower engine, they allow the connecting rods to rotate around the crankpins while supporting the loads transmitted by the pistons. Part number 6B5530HX-STD corresponds to the standard size (STD).
Developed to withstand the stresses of engine tuning, ACL Race Series trimetal connecting rod bearings combine a steel bracket, a copper-lead-tin alloy, a nickel barrier, and an anti-friction layer. Their radial runout helps maintain the oil film when the bearing seats undergo deformation during operation.
The HX suffix identifies a version designed to adjust the oil clearance. For the HX version, ACL specifies approximately 0.025 mm of additional clearance compared to an H version of the same size, on a crankshaft of corresponding sizes. The mounting must be checked after tightening the connecting rod caps.
Technical Specifications
- Type: Connecting rod bush
- Manufacturer: ACL
- Range: ACL Race Series
- Design: trimetal, steel backing, and copper-lead-tin anti-friction plies
- ACL Material: F781 (Race Series connecting rod bushes)
- Manufacturer part number: 6B5530HX-STD
- Dimension: standard dimension (STD)
- Version: HX, increased oil clearance compared to the corresponding H version
- Main engines: VR6
- Manufacturers: Volkswagen | Audi
- Rod journal diameter (nominal dimension): 53.958 to 53.978 mm
- Connecting rod top end bore: 56.8 to 56.819 mm
- Maximum thickness at the top: 1.391 mm
- Maximum width: 17 mm
Engine models compatible with ACL 6B5530HX-STD bearings
This part number applies specifically to the following engine models within the described family: VR6 | R32 | R36 | VR5 | AAA | ABV | AES | AMV | AQP | AUE | AXJ | AXZ | AYL | AYT | AZZ | BAA | BDB | BDE | BDL | BFH. The list of engine codes and applications must be cross-referenced with the exact engine mounting before ordering.
Mounting Recommendations
Mounting Recommendation: Before assembly, check the geometry of the connecting rod top ends, the actual dimensions of the crankshaft journals, and the final oil clearance. Apply the torque values and follow the tightening sequence specified for the engine.
ACL Race Series develops engine bearings for racing and tuning applications, featuring precision manufacturing, shell thickness control, and a trimetal design focused on mechanical strength and control of operating clearances.
-
Thickness in mm1,39
-
Width in mm17,00
-
Engine codeR32 - 3.2L 24V
R36 - 3.6L 24V
VR5 - 2.3L 10V
VR5 - 2.3L 20V
VR6 - 2.8/2.9L 12V
VR6 - 2.8L 24V -
Make (Engine)Audi
Volkswagen -
Rod Journal Diameter in mm53,96
53,98 -
Max. connecting rod bore in mm56,82
-
Min. connecting rod bore in mm56,80