EVANS Vintage Cool Waterless Coolant for Pre-war Vehicles 25 Liters

EVANS waterless coolant is the result of decades of research and development.

Engineers specially created VINTAGE COOL 180° for pre-war vehicles with engines featuring cast-iron blocks and numerous copper and brass components. This coolant keeps engines at the right temperature in the toughest conditions.

* The coolant that lasts a lifetime:

EVANS coolant not only improves your cooling system, it also extends the life of your engine. This protection will be active for the life of the engine without being replaced!

Water-free - No overheating:

The boiling point of EVANS coolant is above 180°C.

Water-free - Corrosion-free

EVANS water-free coolant prevents and eliminates corrosion.

Waterless - Pressureless

EVANS coolant reduces pressure in the cooling circuit.

Water-free - Scale-free:

By preventing the build-up of hard scale, EVANS coolant prevents inefficient heat transfer.

Waterless - More power:

Premature detonation associated with overheating is eliminated with this water-free coolant.

USE :

To guarantee the performance of EVANS coolant, it is important to follow the instructions below:

1/ Remove the coolant from your cooling system, including the heater unit.

2/ Fill the circuit with EVANS hygroscopic preparation fluid (Ref: EV-PREP-FLUID). This fluid removes all dirt, scale debris and other residues which can impair EVANS coolant performance.

3/ Start the engine until it reaches normal operating temperature, then allow it to cool. Drain the cooling system again.

4/ Fill the cooling system with water-free EVANS coolant. Run the engine up to normal operating temperature to expel air from the system.

5/ After first use, check coolant level and top up if necessary.

Capacity : 25L